| Step | | Procedure & Parts & Tools |
| 1 |
|
TURN KEY TO TURN OFF POWER TO MACHINE
|
| 3 |
|
LOCATE THE DRAIN HOSES ON THE BACK OF THE MACHINE.
|
| 4 |
|
PULL TO REMOVE THE HOSES. PLACE HOSES NEAR DRAIN AND REMOVE CAPS
|
| 6 |
|
REMOVE THE TANK BOLT ON RIGHT SIDE OF THE MACHINE.
| Ratchet-Socket metric 13mm |
|
|
| 7 |
|
LIFT THE TANK TO OPEN THE MACHINE, AND REMOVE BATTERIES.
|
| 8 |
|
REMOVE BRUSH GUIDE WHEEL WITH TWO 5MM ALLEN HEAD SCREWS
| Wrench-Allen metric 5.0mm |
|
|
| 9 |
|
REMOVE THE REMAINING ALLEN HEAD SCREWS AROUND THE BRUSH SHROUD
| Wrench-Allen metric 5.0mm |
|
|
| 10 |
|
LIFT UP TO REMOVE THE BRUSH SHROUD.
|
| 11 |
|
REMOVE THE MOTOR LEADS AT THE CONNECTION BLOCK TO THE LEFT OF THE MOTOR. USE A SMALL FLATHEAD SCREWDRIVER TO LOOSEN THE SET SCREWS.
| Screwdriver-flat tip |
|
|
| 12 |
|
PULL TO REMOVE THE SOLUTION LINES TO THE RIGHT OF THE MOTOR
|
| 13 |
|
UNDERNEATH THE DECK, LOCATE AND PULL TO REMOVE THE BRUSH DECK COTTER PIN
|
| 14 |
|
PULL BRUSH DECK OFF THE SHAFT TO REMOVE FROM MACHINE. TURN DECK UPSIDE DOWN AND PLACE ON WORK BENCH
|
| 16 |
|
DISCONNECT TRACTION DRIVE WIRES FROM THE POWER BOARD
|
| 17 |
|
SHUT TANK AND REMOVE THE DRAIN HOSES AND HOSE CLAMPS.
| Screwdriver-flat tip |
|
|
| 18 |
|
REMOVE THE 2 13MM NUTS ON THE FOOT PEDAL. SLIDE THE PEDAL OUT TOWARDS THE BACK.
| Ratchet-Socket metric 13mm |
|
|
| 19 |
|
MOVE SQUEEGEE LIFT ARM TO THE SIDE, STAND MACHINE UP ON END (MAY SECURE THE TANKS AS WELL)
|
| 20 |
|
REMOVE BOTH DRIVE WHEELS
| Ratchet-Socket metric 13mm |
|
|
| 21 |
|
REMOVE THE 4 TRANSAXLE MOUNTING BOLT (4 PER SIDE)
| Ratchet-Socket metric 13mm |
|
|
| 22 |
|
CUT ZIP TIES AND PULL THE DRIVE MOTOR'S WIRES THROUGH THE BOTTOM OF THE FRAME.
|
| 99 |
|
REVERSE STEPS TO INSTALL A NEW DRIVE MOTOR (TRANSAXLE). DOUBLE CHECK NEW TRANS FOR OIL AND KEYWAYS.
|